FD005 installation with no screws
How to Fit FD005 Seals with no screws
Step 1
Firstly Peel the door seal out from behind the plastic liner. Sometimes this can be easy and other times difficult. Try to pull the entire flap that sits in the insulation right out, as it will make fititng the new seal easier.
You may need to cut the old seal with a pair of scissors or blade as shown below to help you remove it from the fridge..
Step 2
Firstly get the door seal to sit in the corner under the plastic liner by putting the small lip of the material underneath.
Once you have hooked it in, slide the lip down, so it sits nicely in the corner with the top part and side part underneath the corner.
Step 3
Repeat this with both top corners. Then attempt to push the lip underneath all of the upper side of the liner with the small lip.
Step 4
In some areas it will be necessary to push the liner out a little with a screwdriver, to allow extra room to push the seals lip underneath.
Step 5
Once you have done this, your seal should be on quite nicely. There may be gaps which you can fix using our troubleshooting instructions.